Western Telematic APS-8M - Manual (Page 63)

11-3
Command Reference Guide
11.3. Command Summary
Function Command Syntax
Command Availability
Supervisor Non-Supervisor
Enter Command Mode [Enter] X X
Exit Command Mode /X [Enter] X X
Help Menu /H [Enter] X X
Display Site ID /J [Enter] X X
Display Port Status /S [Enter] X X
Display Port Diagnostics /SD [Enter] X X
Display Port Parameters
(Who)
/W [n] [Enter] X X
Display Password
Directory
/V [Enter] X
Set System Parameters /F [Enter] X
Set RS232 Port
Parameters
/P <x> [Enter] X
Copy RS232 Port
Parameters
/CP [Enter] X
Connect /C <x> [x] [Enter] X X
Resident Disconnect ^X X X
Third Party Disconnect /D[/Y] <x> [x] [Enter]
/D[/Y] * [Enter]
X
Unlock All Ports (Invalid
Access)
/UL [Enter] X
Erase Buffer /E[/Y] <x> [x] [Enter]
/E[/Y] * [Enter]
X
Default & Test /I[/Y] [Enter] X
Save Parameters /U [Enter] X
Upgrade Firmware /UF [Enter] X

Supervisor Mode displays parameters for all ports; Non-Supervisor Mode
only displays parameters for ports allowed by Port Password.

Ports and passwords that do not permit access to Supervisor Mode can
only view parameters for the ports that are specifically allowed by the
password entered at log in.

Ports and passwords that do not permit access to Supervisor Mode are not
allowed to perform a Third Party Connect.

Resident Disconnect: Disconnects your resident port from another port.
Note that the Resident Disconnect Sequence can be redefined via the Port
Configuration Menus.

Third Party Disconnect: Disconnects two or more nonresident ports.
Must be issued from a third port where Supervisor Mode is active.