Western Telematic APS-8M - Manual (Page 70)

11-10
APS-8M Asynchronous Port Switch; User’s Guide
/W Display Port Parameters (Who)
Displays detailed configuration information for an individual port. Ports with
User Level command capability cannot display parameters for other ports. If
you have logged into command mode using a port and password that permit
Supervisor Mode, the /W command can display information for any
APS-8M port. However, if you have logged into command mode using a port
or password that do not permit Supervisor Mode, the /W command will only
display information for your resident port. For more information, please refer
to Section 7.3.
Availability: Supervisor Mode / Non-Supervisor Mode
Format:
/W [x] [Enter]
Where x is the Port number or name. If the "x" argument is omitted,
parameters for your resident port will be displayed.
Response: Displays port parameters.
Example: To display parameters for a port named "SERVER", access the
Command Mode from a port with Supervisor Level command capability, and
type /W SERVER [Enter].
/X Exit Command Mode
Exits command mode. When issued at the Net Port, also ends the telnet
session. Note that exiting from command mode will not terminate port
connections.
• Any-to-Any Mode: Exits command mode.
• Modem Mode: Disconnects and resets modem, hang-up message is sent,
hardware line to modem drops for 500 ms, and modem reset string is sent.
Availability: Supervisor Mode / Non-Supervisor Mode
Format:
/X [Enter]
Response: Disconnected