Western Telematic APS-8M - Manual (Page 66)

11-6
APS-8M Asynchronous Port Switch; User’s Guide
/D Third Party Disconnect
Invoke the /D command at your resident port to disconnect two other ports.
The /D command cannot be used to disconnect your resident port. To
disconnect your resident port, issue the Resident Disconnect Sequence or wait
for the Timeout Period to elapse (if enabled).
Availability: Supervisor Mode Only
Format:
/D[/Y] <x> [x] [Enter]
Where:
/Y (Optional) suppresses the "Sure?" prompt.
x
Is the number or name of the port(s) to be disconnected.
To Disconnect all ports, enter an asterisk.
Response:
Verbose: "Are you Sure (y/n)?", if Y, unit will respond with
"Disconnected".
Terse: 5, if Y, unit will respond with 3.
Example: To disconnect Port 2 from Port 3 without the "Sure?" prompt,
access command mode using a port and password that permit Supervisor
Mode, and type one of the following commands:
/D/Y 2 [Enter] or /D/Y 3 [Enter]
/E Erase Buffer
Erases data from the buffer for a specified port or several ports. Note that
erased data cannot be recovered.
Availability: Supervisor Mode Only
Format:
/E[/Y] <x> [x] [Enter]
Where:
x Is the number or name of the port buffer(s) to be cleared.
To erase buffers for all ports, enter an asterisk.
/Y (Optional) Suppresses the "SURE? (Y/N)" prompt.
Response:
Verbose: "Are You Sure (y/n)?", if Y, the unit will respond with "OK".
Terse: 5, if Y, the unit will respond with 0.
Example: To clear the buffer for Port 3, access command mode using a port
and password that permit Supervisor Mode, and type /E 3 [Enter].