Xilinx SP605 - Manual (Page 63)

SP605 Hardware User Guide www.xilinx.com 63
UG526 (v1.8) September 24, 2012
Appendix B
Default Jumper and Switch Settings
Table B-33 shows the default switch settings and Table B-34, page 64 shows the default
jumper settings for the SP605.
Table B-33: Default Switch Settings
REFDES Function/Type Default
SW2 Board power slide-switch off
SW1
FPGA mode 2-pole DIP switch, Slave SelectMAP
default selects System ACE CF configuration
2 M1 = 1 on
1 M0 = 0 off
S1
System ACE CF configuration and image select
4-pole DIP switch
4 SysAce Mode = 1 on
3 SysAce CFGAddr2 = 0 off
2 SysAce CFGAddr1 = 0 off
1 SysAce CFGAddr0 = 0 off
S2
User GPIO 4-pole DIP switch
4 off
3 off
2 off
1 off