Yamaha MOTIF XS7 EN - Manual (Page 126)

Editing a Normal Voice
MOTIF XS Owner’s Manual 126
V
oice mode
Song mode
P
attern mode
Mixing mode
Master mode
Utility mode
File mode
P
erf
ormance
mode
Sampling
mode 1
Sampling
mode 2
Ref
erence
Equalizer (EQ) Settings—[F6] EQ
From this display, you can set the EQ parameters for each
Element.
1 Type
Determines the EQ Type. The number of parameters and
values available differs depending on the selected EQ
type.
Settings:
2 Band, PEQ
See below.
Boost 6, Boost 12, Boost 18
Boosts the entire band of the selected Element by +6dB, +12dB, and
+18dB respectively.
thru
If you select this, the equalizers are bypassed and the entire signal is
unaffected.
This is a “shelving” equalizer, which combines separate
high and low frequency bands.
2 Low Frequency
Determines the standard frequency of the lower EQ band.
Settings: 50.1 Hz – 2.00 kHz
3 High Frequency
Determines the standard frequency of the higher EQ band.
Settings: 503.8 Hz – 10.1 kHz
4 Low Gain
Determines the amount by which signals below the Low
Frequency (
2) will be boosted/attenuated.
Settings: -12.00 dB – +0.00 dB – +12.00 dB
5 High Gain
Determines the amount by which signals above the High
Frequency (
3) will be boosted/attenuated.
Settings: -12.00 dB – +0.00 dB – +12.00 dB
The Parametric EQ for the single band is used to attenuate
or boost signal levels (gain) around the Frequency. This
type features 32 different “Q” settings, which determine the
frequency band width of the equalizer.
2 Low Frequency
Determines the center frequency.
Settings: 139.7 Hz – 12.9 kHz
4 Low Gain
Determines the amount by which signals below the Low
Frequency (
2) will be boosted/attenuated.
Settings: -12.00 dB – +0.00 dB – +12.00 dB
6 Q
Determines the Q (bandwidth) for the band. The lower the
setting, the greater the bandwidth. The higher the setting,
the smaller the bandwidth.
Settings: 0.7 – 10.3
When the EQ Type is set to “2 Band”
23
45
1
EQ Type
When the EQ Type is set to “PEQ”
2
4
6
1
EQ Type