ZyXEL Communications Prestige 642 - Manual (Page 76)

Prestige 642 ADSL Internet Access Router
Remote Node Configuration 4-5
will disconnect if the negotiated protocol is different from that in the user profile, even when the negotiated
protocol is stronger than specified. If you encounter the case where the peer disconnects right after a
successful authentication, please make sure that you specify the correct authentication protocol when
connecting to such an implementation.
4.1.4 Editing PPP Options
To edit the remote node PPP Options, move the cursor to the Edit PPP Options field in Menu 11.1 -
Remote Node Profile
, and use the space bar to select Yes. Press ENTER to open Menu 11.2, as shown
next.
Figure 4-3 Menu 11.2 - Remote Node PPP Options
The following table describes the Remote Node PPP Options Menu, and contains instructions on how to
configure the PPP options fields.
Table 4-2 Remote Node PPP Options Menu Fields
Field Description Option
Standard
PPP
Encapsulation Select the CISCO PPP only when this remote node is
a Cisco machine; otherwise, select the Standard
PPP.
CISCO
PPP
Compression Turn on/off Stac Compression. The default for this
field is Off.
On/Off
(Default =
Off)
Once you have completed filling in Menu 11.2 – Remote Node PPP Options, press [ENTER] at the
message [Press ENTER to Confirm…] to save your configuration, or press [Esc] at any time to
cancel.
Menu 11.2 - Remote Node PPP Options
Encapsulation= Standard PPP
Compression= No
Press ENTER to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.