ZyXEL Communications XGS-4528F - Manual (Page 82)

Chapter 7 Basic Setting
XGS-4528F User’s Guide
82
Figure 29 Basic Setting > Port Setup
The following table describes the labels in this screen.
Table 13 Basic Setting > Port Setup
LABEL DESCRIPTION
Port This is the port index number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port
basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Active Select this check box to enable a port. The factory default for all ports is enabled. A
port must be enabled for data transmission to occur.
Name Type a descriptive name that identifies this port. You can enter up to 64 alpha-
numerical characters.
Note: Due to space limitations, the port name may be truncated in
some web configurator screens.
Type This field displays 10/100/1000M for a 1000Base-T connection and 10G for a 10
Gigabit Ethernet connection.