ZyXEL Communications 1 - Manual (Page 152)

NetAtlas Enterprise 1.00 User’s Guide
151 Chapter 15 Performance
Figure 109 Edit Table Entry
Variable Name Variable Values Variable Set Button Previous and Next Page Buttons
Expand
First
Get
Next
Stop
Set All
Done
Help
The following table describes the labels in this screen.
Table 67 Edit Table Entry
COMMAND DESCRIPTION
Variable Names The first vertical column contains the variable names; these are the
names of fields in the selected table. These names are set by SNMPc
and cannot be changed. Some tables have variable names with an
asterisk to the right of the name. These variables are used as indices into
the table. All index variables must be specified to perform a Set operation.
Variable Values The second vertical column contains the variable values in pull down list
boxes. You can change the value by typing into the pull down edit box. If
the variable has integer aliases defined in the MIB, you can select an
alias by clicking on the down arrow and selecting an item from the drop
down list. You must enter the variable value in the proper format. Use the
expand button (see next section) to view the variable type.
Variable Set Button Each variable value has a small Set button to the right. Click this Set
button to perform an SNMP set on only one variable. Set buttons are
grayed for variables that are read-only.
Previous/Next Page
Buttons
Each page shows up to ten variables. The page number and total number
of pages are displayed in the top right corner. Use the >> button to move
to the next page and click the << button to move to the previous page.
Expand Click the Expand button to expand the view of the active variable value
edit box. First click on the edit box, then select the Expand button.
First Click the First button to obtain the first entry of the table from the node.
The variable values will be updated. You do not need to enter index
values - they will be ignored.
Get Click the Get button to obtain the selected table entry. Enter all of the
index values to select a table entry. If you have already displayed an
entry, and perhaps modified the value boxes, you can Click the Get
button to refresh the variable values.