ZyXEL Communications 1 - Manual (Page 96)

NetAtlas Enterprise 1.00 User’s Guide
95 Chapter 10 System Configuration
Figure 72 Configuration: System Configuration: Remote Management
The following table describes the labels in this screen.
Table 29 Configuration: System Configuration: Remote Management
LABEL DESCRIPTION
Services This panel displays the services that you may use to remotely manage the
switch. Select the check box(es) to allow remote management using the
service(s).
Port Enter the number of the server port to use with the corresponding service.
Apply Click Apply to save the changes back to the switch.
Secured Clients Select the check box(es) to enable the client set.
Start To allow a range of computers to use Telnet, FTP, HTTP, ICMP, SSH or
HTTPS services, enter the first IP address in the range here.The default
value for a start and end address is 0.0.0.0, which means you don’t care
which host is trying to use a service (Telnet, FTP, HTTP, SNMP, ICMP, SSH
or HTTPS).If you enter an IP address in this field, the switch will check if the
client IP address matches the value here when a (Telnet, FTP, HTTP,
SNMP, ICMP, SSH or HTTPS) session is up. If it does not match, the
session is disconnected immediately.
End To allow a range of computers to use Telnet, FTP, Web, SNMP or ICMP
services, enter the End IP address in the range here. To allow a single
computer to use Telnet, FTP, HTTP, SNMP, ICMP, SSH or HTTPS
services, enter the same IP address here as in the Start field.