Xerox 50 - Manual (Page 196)

PAPER 9–10 DOCUMENT CENTRE CS 50 USER GUIDE
2
3
4
5
6
7
9
Loading stock into Paper Tray 5
The number of sheets that can be loaded in Paper
Tray 5 (sheet capacity) varies with the weight of
the stock. For more information about paper
weight and requirements, refer to the
Recommended Materials List and the Color
Materials Usage Guide.
Do not load materials above the fill line located on
the paper guide.
KEY POINT: Because of the paper path design of
Paper Tray 5, paper stocks that cause difficulties
being fed from Paper Tray 1, 2, 3, or 4 may be fed
more reliably from Paper Tray 5.
NOTE: Remove all stock from Paper Tray 5 after
the job is complete. Dust and moisture can cause
copy quality defects.
Do not add paper during a copying job.
•
To prevent damage, close Paper Tray 5 when
you are not using it.
•
If you are loading pre-drilled paper, load it with
the undrilled long edge as the leading edge
(holes to the left).
•
Load letter-head paper face up.
•
If you are loading transparencies, load them
with the white stripe side facing down and as
the leading edge. (The leading edge is the
edge that feeds into the copier/printer first.)
Figure 9: Paper Tray 5