Xerox 50 - Manual (Page 81)

DOCUMENT CENTRE CS 50 USER GUIDE 4–9 BASIC COPYING
1
2
3
5
6
7
4
If the Document Centre ColorSeries 50 has a
Sorter/Mailbox, output may be directed to the
Sorter/Mailbox Bins or Offset Catch Tray. The
same options are available if your copier/printer
has a Finisher/Mailbox.
Use the following procedure to determine your
copy output destination.
NOTE: If the Sorter/Mailbox or the Finisher/
Mailbox is configured as a Mailbox, only the Top
Tray option will be visible on the Touch screen.
The Mailbox option is only available when the
Document Centre ColorSeries 50 is in printer
mode. See the Document Centre ColorSeries
50 Printer User Guide.
1 On the Basic Copying tab, touch the appropriated
Copy Output option, as illustrated in Figure 11.
•
Touch Auto Output to direct uncollated output
to the lower Offset Catch Tray. Your stacks will
not be offset.
•
Touch Collated to direct up to 10 sets of
collated output to the Sorter/Mailbox Bins. The
copier/printer screen with read, “The quantity
is outside the acceptable range. It has been
changed to 10,” if you request more than 10
sets.
If you require more than 10 sets, you must
break them up into multiples of 10 to copy.
•
Touch Uncollated to direct uncollated output
to the Sorter/Mailbox Bins.
If the job has more than 10 original
documents, production will pause after the
tenth set has been delivered until you clear
the bins of all output and press Start.
NOTE: Any job that uses Paper Tray 5 is always
delivered to the Offset Catch Tray.
Figure 11: Copy Output options
with optional Sorter/Mailbox