Zebra Technologies Z4Mplus - Manual (Page 105)

97 Configuration
Control Panel LCD Displays
1/18/06 Z4Mplus/Z6Mplus User Guide 13163L-001 Rev. A
Specify IP Protocol
2
Allows either the user (permanent) or the server (dynamic) to select the
IP address. If a dynamic option is chosen, this selection determines the
method(s) by which the print server (wired or wireless) receives the IP
address from the server.
Default: ALL
Selections: ALL, GLEANING ONLY, RARP, BOOTP, DHCP,
DHCP AND BOOTP, PERMANENT
Note • Use of GLEANING ONLY is not recommended when the
Wireless Print Server is installed.
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (–) to scroll through the options.
3. Press SELECT to accept any changes and deselect the parameter.
Specify IP Address
2
This parameter allows you to select the IP address if PERMANENT was
chosen in IP PROTOCOL. (If a dynamic option was chosen, the user
cannot select the address.)
To change the value shown:
1. Press SELECT to select the parameter.
2. Press MINUS (–) to move the cursor.
3. Press PLUS (+) to increase the value of the digit.
4. Press SELECT to accept any changes and deselect the parameter.
Specify Subnet Mask
2
This parameter selects the part of the IP address that is considered to be part
of the local network. It can be reached without going through the default
gateway.
To change the value shown:
1. Press SELECT to select the parameter.
2. Press MINUS (–) to move the cursor.
3. Press PLUS (+) to increase the value of the digit.
4. Press SELECT to accept any changes and deselect the parameter.
Table 10 • Print Server Parameters (Page 2 of 5)
Parameter Action/Explanation
1 Appears only when the ZebraNet Wireless Print Server is installed.
2 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the
print server is recognized, all zeroes (000.000.000.000) will display until the printer obtains an IP address or defaults to
address 192.168.254.254.
3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.
4 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the
card supports LEAP.
IP PROTOCOL
ALL
IP ADDRESS
000.000.000.000
SUBNET MASK
000.000.000.000