Zebra Technologies Z4Mplus - Manual (Page 48)

Operations
Load Media in Cutter Mode 40
13163L-001 Rev. A Z4Mplus/Z6Mplus User Guide 1/18/06
Load Media in Cutter Mode
This section applies only if the Cutter Mode is installed ( Figure 18 ).
Figure 18 • Cutter Mode
To load media in Cutter-Off Mode, complete these steps:
1. Set the printer to Cutter mode. See Select Print Mode on page 75 for instructions.
2. Insert media into the printer. See Insert Media into the Printer on page 29 for instructions.
1
Printhead assembly
2
Transmissive sensor
3
Media supply guide
4
Media supply hanger
5
Dancer
6
Media guide
7
Printhead release latch
8
Cutter module
9
Catch tray
1
2
3
4
5 6 7
8
9