Zebra Technologies Z4Mplus - Manual (Page 107)

99 Configuration
Control Panel LCD Displays
1/18/06 Z4Mplus/Z6Mplus User Guide 13163L-001 Rev. A
Select Encryption Mode
1,3
Select whether to use 40-bit encryption, 128-bit encryption, or no
encryption.
Important • If using encryption, use the ^WE ZPL command to set
the value for the active encryption key. Failure to do so can disable
the wireless system. For more information, see the Wireless Print
Server User Guide.
Default: OFF
Selections: OFF, 40-BIT, 128-BIT
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (–) to scroll through the options.
3. Press SELECT to accept any changes and deselect the parameter.
Select Encryption Index
1,3
Use this parameter to tell the printer which encryption key to use.
Important • Use the ^WE ZPL command to set the value for the
active encryption key. Failure to do so can disable the wireless
system. For more information, see the Wireless Print Server User
Guide.
Default: 1
Selections: 1, 2, 3, 4
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (–) to scroll through the options.
3. Press SELECT to accept any changes and deselect the parameter.
Table 10 • Print Server Parameters (Page 4 of 5)
Parameter Action/Explanation
1 Appears only when the ZebraNet Wireless Print Server is installed.
2 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the
print server is recognized, all zeroes (000.000.000.000) will display until the printer obtains an IP address or defaults to
address 192.168.254.254.
3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.
4 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the
card supports LEAP.
ENCRYPTION MODE
OFF
ENCRYPT. INDEX
1