ZyXEL Communications G.SHDSL.bis 4-port Security Gateway P-793H - Manual (Page 318)

P-793H User’s Guide
318 Chapter 33 System Information & Diagnosis
Figure 198 Menu 24.1: System Maintenance - Status
The following table describes the fields present in Menu 24.1 - System Maintenance -
Status. These fields are read-only and meant for diagnostic purposes. The upper right corner
of the screen shows the time and date.
Menu 24.1 - System Maintenance - Status 06:28:45
Sat. Jan. 01, 2000
Node-Lnk Status TxPkts RxPkts Errors Tx B/s Rx B/s Up Time
1-ENET N/A 0 0 0 0 0 0:00:00
2 N/A 0 0 0 0 0 0:00:00
3 N/A 0 0 0 0 0 0:00:00
4 N/A 0 0 0 0 0 0:00:00
5 N/A 0 0 0 0 0 0:00:00
6 N/A 0 0 0 0 0 0:00:00
7 N/A 0 0 0 0 0 0:00:00
8 N/A 0 0 0 0 0 0:00:00
My WAN IP (from ISP): 0.0.0.0
Ethernet: WAN:
Status: 100M/Full Duplex Tx Pkts: 4210 Line Status: Down
Collisions: 0 Rx Pkts: 4466 Transfer Rate: 0 kbps
CPU Load = 1.27%
Press Command:
COMMANDS: 1-Reset Counters ESC-Exit
Table 118 Menu 24.1: System Maintenance - Status
FIELD DESCRIPTION
Node-Lnk This field is the remote node index number and link type (encapsulation).
Status This field displays Down (line is down), Up (line is up or connected) if you're using
Ethernet encapsulation and Down (line is down), Up (line is up or connected), Idle
(line (ppp) idle), Dial (starting to trigger a call) and Drop (dropping a call) if you're
using PPPoE encapsulation. It displays N/A if the port is not connected.
TxPkts This is the number of packets transmitted from the ZyXEL Device to the remote
node.
RxPkts This is the number of packets received by the ZyXEL Device from the remote
node.
Errors This is the number of error packets on this connection.
Tx B/s This field shows the transmission rate in bytes per second on this port.
Rx B/s This field shows the reception rate in bytes per second on this port.
Up Time This is the total amount of time the this channel has been connected to the remote
node.
My WAN IP (from
ISP)
This is the IP address assigned by your ISP or the static IP address you set up in
menu 4.
Ethernet: This section displays information about the LAN ports.
Status This field displays the speed and duplex settings of the LAN ports.
Collisions This is the number of collisions on this port.