Zanussi ZJD1219 - Manual (Page 13)

13
Drying only
Warning! Do not exceed the maximum laundry loads:
- 2.25 kg for linen and cottons
- 1.5 kg for synthetics.
The water tap must be open and the drain hose must be
positioned in the sink or connected to the drain pipe.
1. Load the laundry
2. Depress the ON/OFF button to switch the machine
on.
3. Select the drying programme (for cotton or
synthetics).
4. Depress the Drying Time button until the time you
want appears in the display. The corresponding light
comes on.
5. Press the START/PAUSE button to start the
programme.
6. At the end of the cycle, turn the programme selector
dial to Reset O and press the ON/OFF button again
to switch the appliance off.
7. Remove the laundry.
Automatic washing and drying
(NON-STOP programme)
Warning! For NON-STOP programmes, it is also
essential not to exceed the maximum load sizes of
2.25 kg for cotton and 1.5 kg for synthetics.
1. Load the laundry.
2. Add detergent and fabric softener.
Do not use dosing device/ball when carrying out
the NON-STOP programme because the plastic
material is not designed to withstand the high
drying temperature
.
3. Switch the machine on by depressing the ON/OFF
button.
4. Select the wash programme.
5 Select eventually the required options by means of
the relevant buttons. If possible, do not select a spin
speed lower than that proposed by the appliance to
avoid a too long drying time so saving energy.
In any case the reduction of the spin speed is only
possible after selecting drying. The lowest values
you can select are the following:
- 900 r.p.m. for cottons and 700 r.p.m. for synthetics
6. Select the drying time.
7. Start the programme by depressing the
START/PAUSE button.
8. At the end of the programme, turn the selector dial to
Reset O and press the ON/OFF button again to
switch the machine off.
9. Remove the laundry.
132997370_ZJD1219.qxd 5/31/01 4:42 AM Pagina 13 (Nero/Process Black pellicola)