ZyXEL Communications ES-2108 - Manual (Page 165)

ES-2108 Series User’s Guide
Chapter 27 Introducing the Commands 165
get-community
<property>
Sets the get community.
set-community
<property>
Sets the set community.
trap-community
<property>
Sets the trap community.
trap-destination
<ip>
Sets the IP addresses of up to
four stations to send your
SNMP traps to.
spanning-tree Enables STP on the switch.
<port-list> Enables STP on a specified
port.
<port-list> path-
cost <1-65535>
Sets the STP path cost for a
specified port.
<port-list>
priority <0-255>
Sets the priority for a specified
port.
hello-time <1-10>
maximum-age <6-40>
forward-delay <4-
30>
Sets Hello Time, Maximum Age
and Forward Delay.
help Displays help information.
priority <0-61440> Sets the bridge priority of the
switch.
spq Sets the switch to use Strictly
Priority Queuing (SPQ).
ssh known-hosts <host-
ip> <1024|ssh-
rsa|ssh-dsa> <key>
Adds a remote host to which the
switch can access using SSH
service.
storm-control Enables broadcast storm
control on the switch.
time <Hour:Min:Sec> Sets the time in hour, minute
and second format.
date <month/day/
year>
Sets the date in year, month
and day format.
help Displays help information.
timezone <-
1200|...|1200>
Selects the time difference
between UTC (formerly known
as GMT) and your time zone.
timesync <daytime|time|ntp> Sets the time server protocol.
server <ip> Sets the IP address of your time
server.
trunk <T1|T2> Activates a trunk group.
<T1|T2>interface
<port-list>
Adds a port(s) to the specified
trunk group.
Table 58 Command Summary: Configuration Mode (continued)
COMMAND DESCRIPTION