ZyXEL Communications ES-2108 - Manual (Page 177)

ES-2108 Series User’s Guide
Chapter 28 Command Examples 177
Figure 109 CLI: boot config Command Example
Use the reload config command to restart the system. The following figure shows an
example.
Figure 110 CLI: reload config Command Example
28.6.2 Resetting to the Factory Default
Follow the steps below to reset the switch back to the factory defaults.
1 Enter erase running config to reset the current running configuration.
2 Enter write memory to save the changes to the configuration file.
The following example resets the configuration file to the factory default settings.
Figure 111 CLI: Reset to the Factory Default Example
28.7 no Command Examples
These are the commonly used command examples that belong to the no group of commands.
28.7.1 no mirror-port
Syntax:
no mirror-port
Disables port mirroring on the switch.
An example is shown next.
ras# boot config
ras# reload config
ras# erase running-config
ras# write memory