ZyXEL Communications IES-5005 - Manual (Page 70)

IES-5000/5005/6000 Support Notes
69
Station/
Application server
Authentication
Server (RADIUS)
Authorized
Unauthorized
X
SHDSL/ADSL
modem
SHDSL/ADSL
modem
IES-5000(SLC/ALC)
(Authenticator)
PC 1
(Supplicant)
PC 2
(Supplicant)
Port x Port y
Setting up 802.1x Setting up 802.1x
To set up an 802.1x infrastructure, we need to configure the authenticator, RADIUS
and supplicants. In this example, we will use Microsoft 802.1x client as the supplicant
and ZyXEL Vantage 50 as the RADIUS server. The following sections describe the
procedures.
To set up an 802.1x infrastructure, we need to configure the authenticator, RADIUS
and supplicants. In this example, we will use Microsoft 802.1x client as the supplicant
and ZyXEL Vantage 50 as the RADIUS server. The following sections describe the
procedures.
1. Authenticator Setup: IES-5000 1. Authenticator Setup: IES-5000
1.1 RADIUS settings: 1.1 RADIUS settings:
Enable 802.1x Authentication and specify the RADIUS server IP address, UDP port
and shared Secret on the IES-5000. Make sure you enter the same UDP port and
shared secret as the RADIUS server. Then save the settings to make them take effect.
Enable 802.1x Authentication and specify the RADIUS server IP address, UDP port
and shared Secret on the IES-5000. Make sure you enter the same UDP port and
shared secret as the RADIUS server. Then save the settings to make them take effect.
TGE1> sys sw dot1x enable TGE1> sys sw dot1x enable
TGE1> sys sw dot1x set radius server 192.168.1.3 TGE1> sys sw dot1x set radius server 192.168.1.3
TGE1> sys sw dot1x set radius port 1812 TGE1> sys sw dot1x set radius port 1812
TGE1> sys sw dot1x set radius sec 12345678 TGE1> sys sw dot1x set radius sec 12345678
TGE1> config save TGE1> config save
All contents copyright (c) 2008 ZyXEL Communications Corporation.