Yamaha CLP-555 - Manual (Page 24)

22 ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
The Function Mode
The [FUNCTION] button provides access to a range of functions that give the
CLP-555 extraordinary versatility. The functions are categorized in groups as
follows:
F1 Tuning ............................................................. 23
F2 Scale ............................................................... 23
F3 Dual Mode Functions .................................... 24
F4 Split Mode Functions .................................... 24
F5Metronome Functions ................................... 27
F6
Left Pedal Mode ............................................. 27
F7 Piano Song Part Cancel Volume ................... 27
F8 MIDI Functions ............................................... 28
F9 Backup Functions .......................................... 31
To Select a Function …
...........................................................................
Z
Press the [FUNCTION] button so that its indicator lights.
• Functions cannot be selected during demo/piano song playback or when
the recorder is in operation.
TRANSPOSE SPLIT
X
Use the [<] and [>] buttons (i.e. the [TRANSPOSE] and [SPLIT]
buttons) to select the desired function: F1 through F9.
C
In the case of the Dual Mode (F3), Split Mode (F4), Metronome
(F5), MIDI (F8), and Backup (F9) functions, you will have to press
the [+/YES] button once to enter the respective sub-mode after the
function has been selected, and then use the [<] and [>] buttons
again to select the desired sub-function.
• The Dual or Split mode must be engaged before the F3 and F4 functions
can be selected, respectively. If the corresponding mode is not engaged,
“
F3.- ” or “ F4.- ” will appear on the display and the corresponding sub-
mode will not be available.
• The Dual mode can be engaged while in the Function mode, but the
Function mode must be exited before the Split mode can be engaged.
V
Set the function as required by using the [–/NO] and [+/YES]
buttons (see the individual function descriptions, below).
B
Press the [FUNCTION] button so that its indicator goes out to exit
from the function mode.
FUNCTION
● Operation Example
(sub-mode)
Press [+/YES]
Use [ < ], [ > ]
Use [–/NO], [+/YES]
Press [–/NO] or [+/YES]
once