ZyXEL Communications 650 Series - Manual (Page 299)

Prestige 650 Series User’s Guide
Remote Node Configuration 27-7
Figure 27-3 Menu 11.3 Remote Node Network Layer Options
The next table explains fields in Menu 11.3 – Remote Node Network Layer Options.
Table 27-2 Menu 11.3 Remote Node Network Layer Options
FIELD DESCRIPTION EXAMPLE
IP Address
Assignment Press [SPACE BAR] and then [ENTER] to select Dynamic if the remote
node is using a dynamically assigned IP address or Static if it is using a
static (fixed) IP address. You will only be able to configure this in the ISP
node (also the one you configure in menu 4). All other nodes are set to
Static. Dynamic
Rem IP Addr This is the IP address you entered in the previous menu.
Rem Subnet
Mask Type the subnet mask assigned to the remote node.
My WAN
Addr Some implementations, especially UNIX derivatives, require separate IP
network numbers for the WAN and LAN links and each end to have a
unique address within the WAN network number. In that case, type the IP
address assigned to the WAN port of your Prestige.
NOTE: Refers to local Prestige address, not the remote router address.
NAT Press [SPACE BAR] and then [ENTER] to select Full Feature if you have
multiple public WAN IP addresses for your Prestige.
Select SUA Only if you have just one public WAN IP address for your
Prestige. The SMT uses Address Mapping Set 255 (menu 15.1 - see
section 30.3.1).
Select None to disable NAT.
SUA Only
Menu 11.3 - Remote Node Network Layer Options
IP Options: Bridge Options:
IP Address Assignment= Dynamic Ethernet Addr Timeout (min)= N/A
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= Full Feature
Address Mapping Set= 2
Metric= 2
Private= No
RIP Direction= None
Version= RIP-1
Multicast= None
IP Policies= 3,4,5,6
Press ENTER to Confirm or ESC to Cancel: