ZyXEL Communications 650 Series - Manual (Page 348)

Prestige 650 Series User’s Guide
31-10 Filter Configuration
Figure 31-11 Menu 21.1.x.1 TCP/IP Filter Rule
The following table describes how to configure your TCP/IP filter rule.
Table 31-3 Menu 21.1.x.1 TCP/IP Filter Rule
FIELD DESCRIPTION EXAMPLE
Filter # This is the filter set, filter rule coordinates, for instance, 2,
3 refers to the second filter set and the third filter rule of
that set. 1,1
Filter Type Use [SPACE BAR] and then [ENTER] to choose a rule.
Parameters displayed for each type will be different.
Choices are TCP/IP Filter Rule or Generic Filter Rule. TCP/IP Filter Rule
Active Select Yes to activate or No to deactivate the filter rule. No
(default)
IP Protocol This is the upper layer protocol, for example, TCP is 6,
UDP is 17 and ICMP is 1. The value must be between 0
and 255. A value of O matches ANY protocol. 0 to 255
IP Source Route IP Source Route is an optional header that dictates the
route an IP packet takes from its source to its destination.
If Yes, the rule applies to any packet with an IP source
route. The majority of IP packets do not have source
route. No
(default)
Destination:
Menu 21.1.1.1 - TCP/IP Filter Rule
Filter #: 1,1
Filter Type= TCP/IP Filter Rule
Active= No
IP Protocol= 0 IP Source Route= No
Destination: IP Addr=
IP Mask=
Port #=
Port # Comp= None
Source: IP Addr=
IP Mask=
Port #=
Port # Comp= None
TCP Estab= N/A
More= No Log= None
Action Matched= Check Next Rule
Action Not Matched= Check Next Rule
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.