Yeoman YM-CL8HB - Manual (Page 11)

11
—
Fit the plug supplied into the hole where the riddling
mechanism is normally located and secure with
bolt and clamp (also supplied, see Diagram 15).
15
PR8865
Plug
Clamp
Bolt
—
Replace the log bar.
9. ExTENDED BURNING
9.1 It is possible to get the appliance to burn for extended
periods of time. In order to do this:
—
De-ash prior to final refuelling.
—
Set air controls to low combustion settings.
This will gradually blacken the glass but it will clear when
operated at a high temperature for a short period.
—
Use smokeless fuel or small, thick logs.
10. OVER-FIRING
10.1 Do not over-fill with fuel or run at high temperatures for
long periods or over-firing can occur. If the flue pipe, flue
collar or top plate glow red the appliance is over-firing.
Close the air controls to reduce the temperature.
10.2 Over-firing can cause permanent damage to the
appliance.
8. WOOD BURNING TRAY
8.1 In order to burn wood continuously in this appliance a
Wood Burning Tray should be fitted (see Diagram 12).
12
PR8862
Front edge
8.2 Remove the multi-fuel grate from the appliance (see
Installation Instructions, Section 5).
8.2 To fit the Wood Burning Tray:
—
Remove the log bar.
—
Hold the tray flat with the front edge pointing forwards
(see Diagram 12).
—
Tilt diagonally and insert through the front of the stove
(see Diagram 13).
13
PR8863
—
Place tray flat on the fixings on the firebed (see
Diagram 14).
14
PR8864
USER INSTRUCTIONS