ZyXEL Communications P-334 - Manual (Page 174)

Prestige 334 User’s Guide
173 Chapter 15 VPN Screens
Peer Content The configuration of the peer content depends on the peer ID type.
•
For IP, type the IP address of the computer with which you will make the
VPN connection. If you configure this field to 0.0.0.0 or leave it blank, the
Prestige will use the address in the Secure Gateway Address field (refer
to the Secure Gateway Address field description).
• For DNS or E-mail, type a domain name or e-mail address by which to
identify the remote IPSec router. Use up to 31 ASCII characters including
spaces, although trailing spaces are truncated. The domain name or e-mail
address is for identification purposes only and can be any string.
It is recommended that you type an IP address other than 0.0.0.0 or use the
DNS or E-mail ID type in the following situations:
•
When there is a NAT router between the two IPSec routers.
When you want the Prestige to distinguish between VPN connection requests
that come in from remote IPSec routers with dynamic WAN IP addresses.
IKE Phase 1 A phase 1 exchange establishes an IKE SA (Security Association).
Negotiation Mode Select Main or Aggressive from the drop-down list box. The Prestige's
negotiation mode should be identical to that on the remote secure gateway.
Encryption Algorithm Select DES or 3DES from the drop-down list box. The Prestige's encryption
algorithm should be identical to the secure remote gateway. When DES is
used for data communications, both sender and receiver must know the same
secret key, which can be used to encrypt and decrypt the message. The DES
encryption algorithm uses a 56-bit key. Triple DES (3DES) is a variation on
DES that uses a 168-bit key. As a result, 3DES is more secure than DES. It
also requires more processing power, resulting in increased latency and
decreased throughput.
Authentication
Algorithm
Select SHA1 or MD5 from the drop-down list box. The Prestige's
authentication algorithm should be identical to the secure remote gateway.
MD5 (Message Digest 5) and SHA1 (Secure Hash Algorithm) are hash
algorithms used to authenticate the source and integrity of packet data. The
SHA1 algorithm is generally considered stronger than MD5, but is slower.
Select SHA-1 for maximum security.
SA Life Time Define the length of time before an IKE SA automatically renegotiates in this
field. It may range from 60 to 3,000,000 seconds (almost 35 days). A short SA
Life Time increases security by forcing the two VPN gateways to update the
encryption and authentication keys. However, every time the VPN tunnel
renegotiates, all users accessing remote resources are temporarily
disconnected.
Key Group You must choose a key group for phase 1 IKE setup. DH1 (default) refers to
Diffie-Hellman Group 1 a 768 bit random number. DH2 refers to Diffie-Hellman
Group 2 a 1024 bit (1Kb) random number.
Pre-Shared Key Type your pre-shared key in this field. A pre-shared key identifies a
communicating party during a phase 1 IKE negotiation. It is called "pre-
shared" because you have to share it with another party before you can
communicate with them over a secure connection.
IKE Phase 2 A phase 2 exchange uses the IKE SA established in phase 1 to negotiate the
SA for IPSec.
Encapsulation Mode Select Tunnel mode or Transport mode from the drop down list-box. The
Prestige's encapsulation mode should be identical to the secure remote
gateway.
Table 52 VPN IKE: Advanced
LABEL DESCRIPTION