ZyXEL Communications P-334 - Manual (Page 321)

Prestige 334 User’s Guide
Chapter 34 VPN/IPSec Setup 320
Port Start 0 is the default and signifies any port. Type a port number from 0 to 65535. You cannot
create a VPN tunnel if you try to connect using a port number that does not match this
port number or range of port numbers.
Some of the most common IP ports are: 21, FTP; 53, DNS; 23, Telnet; 80, HTTP; 25,
SMTP; 110, POP3
End Enter a port number in this field to define a port range. This port number must be
greater than that specified in the previous field. This field is N/A when 0 is configured in
the Port Start field.
Remote Remote IP addresses must be static and correspond to the remote IPSec router’s con-
figured local IP addresses. The remote fields are N/A when the Secure Gateway
Address field is configured to 0.0.0.0.
Two active SAs cannot have the local and remote IP address(es) both the same. Two
active SAs can have the same local or remote IP address, but not both. You can
configure multiple SAs between the same local and remote IP addresses, as long as
only one is active at any time.
Addr Type Press [SPACE BAR] to choose SINGLE, RANGE, or SUBNET and press [ENTER].
Select SINGLE with a single IP address. Use RANGE for a specific range of IP
addresses. Use SUBNET to specify IP addresses on a network by their subnet mask.
IP Addr Start When the Addr Type field is configured to Single, enter a static IP address on the net-
work behind the remote IPSec router.
When the Addr Type field is configured to Range, enter the beginning (static) IP
address, in a range of computers on the network behind the remote IPSec router.
When the Addr Type field is configured to SUBNET, enter a static IP address on the
network behind the remote IPSec router.
This field displays N/A when you configure the Secure Gateway Address field to
0.0.0.0.
End/Subnet
Mask
When the Addr Type field is configured to Single, this field is N/A.
When the Addr Type field is configured to Range, enter the end (static) IP address, in
a range of computers on the network behind the remote IPSec router.
When the Addr Type field is configured to SUBNET, enter a subnet mask on the net-
work behind the remote IPSec router.
This field displays N/A when you configure the Secure Gateway Address field to
0.0.0.0.
Port Start 0 is the default and signifies any port. Type a port number from 0 to 65535. Someone
behind the remote IPSec router cannot create a VPN tunnel when attempting to con-
nect using a port number that does not match this port number or range of port num-
bers.
Some of the most common IP ports are: 21, FTP; 53, DNS; 23, Telnet; 80, HTTP; 25,
SMTP; 110, POP3.
End Enter a port number in this field to define a port range. This port number must be
greater than that specified in the previous field. This field is N/A when 0 is configured in
the Port Start field.
Table 105 Menu 27.1.1 IPSec Setup
FIELD DESCRIPTION