3Com 09-1632-000 - Manual (Page 12)

12 C ONFIGURING Y OUR O FFICE C ONNECT NETB UILDER 10 B RIDGE /R OUTER
Configuration Procedure
This section provides step by step instructions for
configuring the set up shown in Figure 5.
Figure 5 Office A Configuration
In these instructions, your site is Office A.
To configure your OfficeConnect NETBuilder 10
bridge/router, follow the steps in the following sections:
■
Configuring ISDN Lines:
■
If you are located in North America, use the
procedure in “Configuring ISDN (In North America)”
on page 13.
■
If you are located outside North America, use the
procedure in “Configuring ISDN (Outside North
America)” on page 16.
NETBuilder Router CONNECT O F F I C E
System W AN ISDN LAN Line
Act
Line
Error Link Conne ct Fault
Send Active Fault Line Active Fault Run Load Test B1 B 2 Status Pwr F wd Alert
OfficeConnect
bridge/router
NETBuilder Router CONNECT O F F I C E
System W AN ISDN LAN Line
Act
Line
Error Link Conne ct Fault
Send Active Fault Line Active Fault Run Load Test B1 B 2 Status Pwr F wd Alert
ISP
Internet
Leased line
IPX = CCC
IP = unnumbered
IP 10.1.0.0
Office A
IPX = AAA
Office B
IPX = BBB
IP 20.1.0.0
ISDN
ISDN
Network management system
OfficeConnect
bridge/router
Network management system
OC10.book Page 12 Thursday, May 13, 1999 2:33 PM