3Com 09-1632-000 - Manual (Page 13)

Configuration Procedure 13
■
Configuring Dynamic Dial
■
Configuring Network Addressing for Your Network:
■
If your network uses the IP protocol, use the
procedure in “Configuring IP Network Addressing”
on page 20.
■
If your network uses the IPX network protocol use
the procedure in “Configuring IPX Network
Addressing” on page 23.
■
Configuring PPP Authentication
Additional configuration steps that need to be
performed at Office B are included in “Configuring PPP
Authentication” on page 24. To complete your set up,
you will need to exchange certain information with your
Office B partners.
Configuring ISDN Lines
If you are in North America, you can use the SPIDWizard to
automatically detect your ISDN switch type and SPID
values.
Configuring ISDN (In North America)
To configure your Office A in North America, follow these
steps:
1 Configure ISDN Dial on Demand.
In this procedure you will set the primary and secondary
phone numbers as provided by your telecommunications
carrier for the ISDN paths.
a In the navigation frame, click the Configuration link.
b In the navigation frame, click the IP Routing link.
c In the Dial on Demand ISDN Setup section of the
navigation frame, click the PATH LocalDialNo link.
d In the start field, click the arrow and choose 2.1.
e In the LocalDialNo field, enter the local dial number
string in quotes. For example, enter:
"4085551001"
f Click Apply.
OC10.book Page 13 Thursday, May 13, 1999 2:33 PM