Preconfiguration set up, Set up the nms as a dhcp client, Install the officeconnect on a tabletop – 3Com 09-1632-000 User Manual
Page 7: Cable the bridge/router, Preconfiguration set up 7, Set up the nms as a dhcp client 7, Install the officeconnect on a tabletop 7, Cable the bridge/router 7
Preconfiguration Set Up
7
Preconfiguration Set Up
This section describes the things you need to do before
performing the actual network configuration.
Set Up the NMS as a DHCP Client
Refer to the documentation that came with your PC
operating system for information on how to perform this
set up.
Install the OfficeConnect on a Tabletop
Attach the plastic feet supplied with your OfficeConnect
bridge/router; see Figure 2.
CAUTION
: Do not restrict air flow around the sides and
back of the bridge/router.
Figure 2
Attaching Plastic Feet to OfficeConnect
Bridge/Router
Cable the Bridge/Router
Figure 3 shows the back panel connectors on the
OfficeConnect bridge/routers. Refer to this figure when you
attach or plug in cables.
Remove feet from their adhesive backing.
Attach feet to the bottom of the chassis,
using the semi-circle marks for placement.
OC10.book Page 7 Thursday, May 13, 1999 2:33 PM