3Com 09-1632-000 - Manual (Page 16)

16 C ONFIGURING Y OUR O FFICE C ONNECT NETB UILDER 10 B RIDGE /R OUTER
7 Logically assign the two ISDN paths to port 4.
a In the Dial On Demand ISDN Setup section of the
navigation frame, click the PORT PAths link.
b In the start field, click the arrow and choose 4.
c In the PAths field, enter 2.1, 2.2.
d Click Apply.
8 Enable all paths on port 4.
a In the Dial On Demand ISDN Setup section of the
navigation frame, click the PATH CONTrol link.
b In the start field, click the arrow and choose 2.1
c In the end field, click the arrow and choose 3.
d In the CONTrol field, click the arrow and choose
Enabled.
e Click Apply.
9 If your line speed requirements are different than the
default (64 Kbps), you need to modify your path baud rate
configuration.
a In the Dial On Demand ISDN Setup section of the
navigation frame, click the PATH BAud link.
b In the start field, click the arrow and choose 3.
c In the BAud field, enter your path baud rate. For
example, enter:
128
d Click Apply.
Configuring ISDN (Outside North America)
To configure Office A outside North America, follow these
steps:
1 Configure ISDN Dial on Demand.
Within IP Routing Configuration, set the primary and
secondary phone numbers as provided by your
telecommunications carrier for the ISDN paths.
a In the Dial on Demand ISDN Setup section of the
navigation frame, click the PATH LocalDialNo link.
OC10.book Page 16 Thursday, May 13, 1999 2:33 PM