3Com 09-1632-000 - Manual (Page 5)

C
ONFIGURING
Y
OUR
O
FFICE
C
ONNECT
NETB
UILDER
10
B
RIDGE
/R
OUTER
This guide contains the information you need to install and
configure your OfficeConnect
® NETBuilder ® 10
bridge/router.
The basic configuration that you will establish is shown in
Figure 1. This configuration supports a leased-line
connection between two OfficeConnect bridge/routers. It
also supplies an ISDN dial-on-demand backup line.
As you are configuring your router, you will be asked to
make choices based on what is required on your network.
Figure 1 Basic Configuration
NETBuilder Router CONNECT O F F I C E
System W AN ISDN LAN Line
Act
Line
Error Link Conne ct Fault
Send Active Fault Line Active Fault Run Load Test B1 B 2 Status Pwr F wd Alert
OfficeConnect
bridge/router
NETBuilder Router CONNECT O F F I C E
System W AN ISDN LAN Line
Act
Line
Error Link Conne ct Fault
Send Active Fault Line Active Fault Run Load Test B1 B 2 Status Pwr F wd Alert
ISP
Internet
Leased line
IPX = CCC
IP = unnumbered
IP 10.1.0.0
Office A
IPX = AAA
Office B
IPX = BBB
IP 20.1.0.0
ISDN
ISDN
Network management system
OfficeConnect
bridge/router
Network management system
OC10.book Page 5 Thursday, May 13, 1999 2:33 PM