Edimax Technology BR-6428nS - Manual (Page 96)

95
Local Port Range Please input the range of local (source) port number
that will be affected by this rule. If you want to apply
this rule on port 80 to 90, please input ’80‐90’; if you
want to apply this rule on a single port, just input the
port number, like ‘80’.
Remote IP Address Specify the remote (destination) IP address that will
be affected by this rule. Please input the starting IP
address in the left field, and input the end IP address
in the right field to define a range of IP addresses, or
just input the IP address in the left field to define a
single IP address.
Remote Port Range Please input the range of remote (destination) port
number that will be affected by this rule. If you want
to apply this rule on port 80 to 90, please
input ’80‐90’; if you want to apply this rule on a single
port, just input the port number, like ‘80’.
If the
remote (destination) IP address and /or port number
is universal, just leave it blank.
Traffic Type Please select the traffic type of this rule, available
options are None, SMTP, HTTP, POP3, and FTP. You
can select a specific traffic type for this rule, if you
want to make this rule as a IP address based rule
(apply the limitation on all traffics from / to the
specified IP address / port number), select ‘None’.
Protocol Please select the protocol type of this rule, available
options are TCP and UDP. If you don’t know what
protocol your application uses, please try ‘TCP’ first,
and switch to ‘UDP’ if this rule doesn’t seems to work.
After you finish with all settings, please click ‘save’ button (i), you’ll be brought back to
previous menu, and the rule you just set will appear in current QoS table; if you did
anything wrong, you’ll get an error message when you click ‘Save’ button, please correct
your input by the instructions given by the error message.
If you want to erase all values you just entered. Click ‘Reset’