Edimax Technology WP-S1000 - Manual (Page 8)

7
Back View
PWR: Push this button to switch on the WP-S1000 projector server (the ‘POWER’ led
at the front panel will lit), push this button again to switch off the projector server.
5V DC: Connects to the power connector of power adapter. WARNING: Only use the
power adapter comes with product package, DO NOT replace with other power
adapter!
VGA: Connects to the video cable of your projector or CRT / LCD monitor
(15-pin D-sub connector).
AUDIO: Connects to the audio cable of external speaker or audio amplifier.
(3.5mm audio connector)
LAN: Connects to your local area network (LAN) by network cable.
(RJ-45 network connector)
RESET: When the projector server is not working properly, you can use this button to
clear all settings and restore the WP-S100 to factory default settings: Switch the
projector server off, press and hold the RESET button using a pen or pin, then switch
the projector server on. You should still press and hold ‘RESET’ button, after 10
seconds you can release the RESET button, and all settings in the projector server
will be restored to factory default.
ANT.: Connects to the antenna, please only use the antenna in the product package.
If you need to use other antenna to improve radio reception, please make sure the
antenna you’re using is designed for 2.4GHz radio band. (R-SMA connector)