Edimax Technology AR-7186WnB - Manual (Page 43)

43
You may select Auto setup by ISP list, Dynamic IP Address, Static IP Address,
PPPoE/PPPoA or Bridge Mode.
5.3.1. Auto setup by ISP list
Select Auto setup by ISP list, click NEXT, and the page as shown in the
following figure appears.
The following table describes the parameters in this page:
Field Description
Country Select the country you are in.
ISP Select your Internet Service Provider (ISP).
VPI
Virtual path identifier (VPI) is the virtual path between two
points in an ATM network. Its valid value is between 0 and
255. Enter the correct VPI provided by your ISP.
VCI
Virtual channel identifier (VCI) is the virtual channel between
two points in an ATM network. Its valid value is between 1
and 65535. Enter the correct VCI provided by your ISP.
Connection
Type
Select a connection type from the dropdown list. You may
select PPPoE/ PPPoA/ Dynamic IP/ Static IP/ Routered IP/
Bridge.
5.3.2. Bridge Mode
Select Bridge Mode, click NEXT, and the page shown in the following figure
will appear.