Edimax Technology AR-7186WnB - Manual (Page 71)

71
Field Description
MGCP, SNMP, DNS, DHCP, RIP, RSTP, RTCP and RTP.
Physical Ports Choose an Ethernet interface or WLAN Interface.
Destination
MAC
The Destination MAC address of the rule. If data packets
include the MAC address, the data packets are placed into
the group.
IP
The destination IP address of the rule. If data packets
include the IP address, the data packets are placed into the
group.
Port Range Port Range is from 0 to 65535.
Source MAC
The Source MAC address of the rule. If data packets include
the MAC address, the data packets are placed into the
group.
Protocol ID You can choose TCP/UDP, TCP, UDP, ICMP or IGMP.
Vlan ID Range
Select this option to Activate/Deactivate the 4094 VID on
the 4 different queues. VID (VLAN ID) is the identification
of the VLAN, which is basically used by the standard
802.1Q. It has 12 bits and allows the identification of 4096
(2^12) VLANs. Of the 4096 possible VIDs, a VID of 0 is used
to identify priority frames and value 4095 (FFF) is reserved,
so the maximum possible VLAN configurations are 4,094.
IPP/DS Field You may set IPP/TOS or DSCP.
IP Precedence
Range When IPP/DS field is set to IPP/TOS, you need to enter an
IP precedence range.
Type of Service
Support services including Normal service, Minimize
delay, Maximize throughput, Maximize reliability and
Minimize monetary cost.
DSCP Range DSCP Range is from 0 to 63.
802.1p
Select this option to Activate/Deactivate the 802.1p. IEEE
802.1p establishes eight levels of priority (0–7). Although
network managers must determine actual mappings, IEEE
has made broad recommendations. Seven is the highest
priority which is usually assigned to network-critical traffic
such as Routing Information Protocol (RIP) and Open
Shortest Path First (OSPF) table updates. Five and six are
often for delay-sensitive applications such as interactive