Edimax Technology AR-7186WnB - Manual (Page 47)

47
Field Description
255. Enter the correct VPI provided by your ISP. By default,
VPI is set to 8.
VCI
Virtual channel identifier (VCI) is the virtual channel between
two points in an ATM network. Its valid value is between 1
and 65535. Enter the correct VCI provided by your ISP. By
default, VCI is set to 35.
Connection
Type You can select LLC or VC-Mux. In this example, the
encapsulation mode is set to PPPoE LLC.
After setting, click NEXT, the page as shown in the following figure appears.
Click BACK to modify the settings.
Click NEXT to save the settings.
Click EXIT to cancel the settings.
Note:
After you saving the settings in the Quick Start page, you can view this
wan connection settings in the Interface Setup > Internet page.
5.4. Interface Setup
In the navigation bar, click Interface Setup. The Interface Setup page that is
displayed contains Internet, LAN and Wireless.
5.4.1. Internet
Choose Interface Setup > Internet. The Internet page that is displayed
contains ATM VC, Qos, IPv4/IPv6 and Encapsulation.
Click Internet pane, the page shown in the following figure appears. In this
page, you can configure the WAN interface of your router.