Edimax Technology AR-7186WnB - Manual (Page 51)

51
Field Description
Dynamic Route
Select this option to specify the Routing Information
protocol (RIP) version. You can select RIP1, RIP2-B or
RIP2-M.
Direction
You can select None, Both, IN Only or OUT Only to
specify the RIP direction. None is for disabling the
RIP function. Both means the ADSL Router will
periodically send routing information and accept
routing information then incorporate into routing
table. IN only means the ADLS router will only
accept but will not send RIP packets. OUT only
means the ADLS router will only send but not accept
RIP packets.
Multicast
IGMP (Internet Group Multicast Protocol) is a
session-layer protocol used to establish membership
in a multicast group. The ADSL Router supports both
IGMP version 1 (IGMP v1) and IGMP version 2 (IGMP
v2). Select Disabled to disable it.
IPv6 Address
DHCP IPv6
Enable Provide address assignment to hosts to include
DHCP in local pools. You can choose DHCP or SLAAC.
DHCP PD Enable
IPv6 Prefix Delegation Options for DHCPv6. You may
enable or disable DHCP PD.
MLD Proxy
You may enable or disable MLD Proxy. Mld proxy is
enabled only for route mode. It works in an IPv6
environment.
Dual Stack Lite
Enable
You may Enable or Disable Dual Stack Lite. The ADSL
Router support IPv4/v6 Dual Stack Internet Protocol.
Select Static IP Address in the ISP encapsulation to set static IP information.
You will need to enter the Connection type, IP address, subnet mask and
gateway address provided by your ISP. Each IP address entered must be in the