Edimax Technology AR-7267WnB - Manual (Page 21)

17
Parameter Description
Encapsulation Please check with your ISP the method of multiplexing. In
Bridge Mode, please select “1483 Bridge IP LLC” or “1483
Bridge IP VC-Mux”.
Bridge Interface This router has built-in ADSL modem and is able to connect to
ISP directly. Alternatively, if you want to use the dial up
software to manually connect to the ISP, you have to activate
the ”Bridge Interface”.
Default Route When “Default Router” is enabled, all the packets for
destinations not known by the router's routing table are sent
to the default route. By default, it is enabled.
TCP MSS Option The “TCP MSS Option” enables the configuration of the
maximum segment size (MSS) for transient packets that
traverse a router, specifically TCP segments in the SYN bit set,
when PPPoE is being used in the network. Please specify the
MSS range from 100 to 1452 bytes or 0 byte as the default
value.
NAT NAT (Network Address Translation), an Internet standard that
enables a local-area network (LAN) to use one set of IP
addresses for internal traffic and a second set of addresses for
external traffic. When NAT is enabled, the router will help to
make all necessary IP address translations for the PC
connected to the router to access the Internet.
Dynamic Route Dynamic routing allows routing tables in routers to change as
the possible routes change. This router supports RIP1, RIP2-B
and RIP2-M protocols for dynamic routing. After the RIP
protocol is selected, please choose the RIP direction from
“None”, “Both”, “IN Only” or “OUT Only”.
IGMP Porxy Enable or disable IGMP proxy feature.
When you are done making changes, click on SAVE to save your changes.