Edimax Technology AR-7267WnB - Manual (Page 30)

26
this value too low, it will result in bad performance. Enter a
value from 256 to 2346.
DTIM Determines the interval the Access Point will send its
broadcast traffic. The range is from 1 to 255 and the default
value is 3 beacons.
Wireless Mode 802.11b – It only allows 802.11b wireless network client to
connect this router (maximum transfer rate 11Mbps).
802.11g – It only allows 802.11g wireless network client to
connect this router (maximum transfer rate 54Mbps).
802.11b+g – It only allows 802.11b and 802.11g wireless
network client to connect this router (maximum transfer rate
11Mbps for 802.11b clients, and maximum 54Mbps for
802.11g clients).
802.11n – It only allows 802.11n wireless network client to
connect this router (maximum transfer rate 300Mbps).
802.11g+n – It allows 802.11g, and 802.11n wireless network
client to connect this router (maximum transfer rate 54Mbps
for 802.11g clients, and maximum 300Mbps for 802.11n
clients).
802.11b+g+n – It allows 802.11b, 802.11g, and 802.11n
wireless network client to connect this router (maximum
transfer rate 11Mbps for 802.11b clients, maximum 54Mbps
for 802.11g clients, and maximum 300Mbps for 802.11n
clients).
NOTE: For 802.11b and 802.11g mode, the signals can be
transmitted only by antenna 1 (The antenna in the right side
of the rear panel).
For 802.11n mode: The router is operating in a 2T3R Spatial
Multiplexing MIMO configuration. 2 antennas are for signal
transmitting and 3 antennas are for signal receiving.