Edimax Technology AR-7267WnB - Manual (Page 47)

43
 IP / MAC Filter Rule Editing
Parameter Description
IP/MAC Filter Rule Index This is the item number to record the setting rule.
Active Select “Yes” to enable the current rule, select “No” to cancel the
current rule.
Interface Select which channel (PVC) to configure.
Direction Select the access to the Internet (Outgoing) or from the Internet
(Incoming), or Both.
Rule Type Select to filter through the IP Address or MAC Address.
Source IP Address Enter the start IP Address which will be monitored. If “0.0.0.0” is set, it
means for any IP Address.
Subnet Mask Enter the Subnet Mask based on the Source IP Address.
Port Number LAN users use port number to distinguish one network application over
another such as 21 is for FTP service. The port number range is from 0
to 65535. It is recommended that this option be configured by an
advanced user.
Destination IP Address Enter the start IP Address which will be monitored. If “0.0.0.0” is set, it
means for any IP Address.
Subnet Mask Enter the Subnet Mask based on the Destination IP Address.
Port Number This is the port or port ranges that define the application.
Protocol It is the packet protocol type used by the application. Please select
“TCP”, “UDP” or “ICMP”. For example, FTP service, you have to select
“TCP”.
IP / MAC Filter Listing The IP/MAC Filter Listing will list the IP/MAC Filter rules you have
configured. You can review the settings here.
When you are done making changes, click on SET to save your changes, DELETE to delete the rule with
the parameters you set or CANCEL to exit without saving.