Edimax Technology WD-1000TR - Manual (Page 12)

11
Step 3: Boot up the WD‐1000TX and WD‐1000RX
(1) After the power cord is plugged into the electrical outlet, the WD‐1000TR will be turned on
automatically.
(2) If it is in Standby mode (Both POWER LED of transmitter and receiver are lit in red), press the
POWER button on both transmitter and receiver to turn on the WD‐1000TX and WD‐1000RX. It
will take about 1 minute for the system to boot up.
(3) If it is in Listen mode (Transmitter POWER LED is lit in Red and Receiver POWER LED is lit in
Purple), press the POWER button of Transmitter (Or just plug in Transmitter’s power cord) to
turn on the WD‐1000TX and WD‐1000RX.
Note : During this period, WD‐1000RX will enter Listen mode and once the Transmitter boot up,
the Transmitter will automatically wakes up the Receiver to establish a link.