Edimax Technology WD-1000TR - Manual (Page 20)

19
WD‐1000TR transmitter are powered on.
* Ensure the display setting for your PC (or laptop) had been switched
to clone mode, Projector out mode or dual display mode for enable
external display. (Refer Chapter 4.1 for the detail operation.)
Poor picture quality or
intermittent video
play.
• Check if your video resolution with HDMI input from your PC device
is either 1080p, 1080i, 720p, 576p, or 480p. Please refer to the
“Supported Resolution” chapter where the video frame rate from
your PC device WD‐1000TR can support is defined.
• Press INFO./CHANNEL on the top of WD‐1000RX box to manually
change the wireless channel.
• Ensure the transmission distance is less than 30 feet (LOS).
No audio.
• Check if your TV’s volume is properly set and not in "MUTE" .
• Check if your PC’s (or laptops) audio output has been switched to
HDMI out.
• Check if your PC’s (or laptop’s) audio volume has been turned up.
• Ensure the bit rate of audio from the source device can be supported
by WD‐1000TR. Please refer to the details in Chapter 6, Audio Bit
Rate Support.
If no audio / video
when resume from
PC’s sleep mode.
• Please try to re‐plug the HDMI cable of TX for re‐detect the external
HDMI device
• Please try to reboot WD‐1000TR for re‐synchronize the display
setting.
• Please try to reboot your PC (or laptop)
4.1 Windows OS Display setting of Laptop for enables external display
Š On Windows7 OS :
1. Press key + P key
2. There is a Pop icon displayed on the screen, likes below :
3. Select Clone mode or Extend Display or Project out only to enable external display.