Edimax Technology AR-7286WnB - Manual (Page 45)

45
Field Description
two points in an ATM network. Its valid value is between 1
and 65535. Enter the correct VCI provided by your ISP.
Connection
Type
Select a connection type from the dropdown list. You may
select PPPoE/ PPPoA/ Dynamic IP/ Static IP/ Routered IP/
Bridge.
Bridge Mode .
Static IP Address
Select Static IP Address, click NEXT, and the page as shown in the following
figure will appear.
The following table describes the parameters in this page:
Field Description
VPI
Virtual path identifier (VPI) is the virtual path between two
points in an ATM network. Its valid value is between 0 and
255. Enter the correct VPI provided by your ISP. By default,
VPI is set to 8.
VCI
Virtual channel identifier (VCI) is the virtual channel between
two points in an ATM network. Its valid value is between 1
and 65535. Enter the correct VCI provided by your ISP. By
default, VCI is set to 35.
IP Address Enter the IP address provided by your ISP.
Subnet Enter the subnet mask provided by your ISP.