Edimax Technology AR-7286WnB - Manual (Page 65)

65
The following table describes the parameters and buttons of this page:
Field Description
Destination
IP Address Enter the IP address of the destination device.
IP Subnet
Mask Enter the subnet mask of the destination device.
Gateway IP
Address You can enter the IP address of the next hop in the IP route to
the destination device, or bind with a PVC interface.
Metric The metric cost for the destination.
Announced
in RIP
This parameter determines if the ADSL router will include the
route to this remote node in its RIP broadcasts. If set to Yes,
the route to this remote node will be propagated to other
hosts through RIP broadcasts. If No, this route is kept private
and is not included in RIP broadcasts.
5.5.3. NAT
Click Advanced Setup > NAT, the page shown in the following figure appears.
In this page, you can set up the NAT (Network Address Translation) function
for your ADSL router. This function allows you to share one WAN IP address
for multiple computers on your LAN.
The following table describes the parameters and buttons of this page:
Field Description
Virtual
Circuit Choose a Virtual Circuit Index to set up for the NAT function.
NAT Status
This field shows the current NAT status for the current VC. The
status is enabled or disabled, depending on whether NAT is
enabled for the WAN connection.