Hama VMDD26 - Manual (Page 7)

ENGLISH
Step 3: Add the Vise Assemblies to the Monitor Brackets:
Note: Do not overtighten the 1/4-20 Nut. The Vise Assembly should be able to rotate freely around the Carriage Bolt.
Place the Vise Assembly (f) between the two sides of the Monitor Bracket (e) so that the two jaws point toward the set of 1” diameter
holes and the allen bolt is facing away from the television as shown in the Detailed View of Diagram 3. Place a 2” Carriage Bolt (l)
through the square hole in the side of the Monitor Bracket, through the hole in the Vise Assembly, and then through the square hole in the
other side of the Monitor Bracket also shown in the Detailed View of Diagram 3. Next, tighten a 1/4-20 Nut (m) onto the end of the 2”
Carriage bolt. Repeat this step for the bottom of the Monitor Bracket. Finally, repeat these two steps for the second Monitor Bracket.
Diagram 3 Detailed View
f
m
l
e
Step 4: Attach the Arm Assembly to the Television (Part I)
First, orient each Vise Assembly (f) so that a 1” Diameter Tube (d) will pass through the 1” round hole in the Monitor Bracket (e) and
then between the jaws of the Vise Assembly as shown in Diagram 4a. Insert a 1” Diameter Tube through the top hole in the first Monitor
Bracket also shown in Diagram 4a. Repeat this step for the Bottom hole in the same Monitor Bracket.
Diagram 4a
f
d
e
VMDD26ins_011206_ML.indd 7 1/16/06 4:39:17 PM