STIEBEL ELTRON SHW 200-400 ACE с 06.05.2013 - Manual (Page 24)

24 | SHW ACE www.stiebel-eltron.com
16.3 Heat-up diagram
The heat-up time depends on the cylinder capacity, cold water
inlet temperature and heating output.
At 10 °C cold water temperature and temperature setting "E":
400 300
2
4
6
8
10
12
2
3
4
1
200 84
�0
2�
02
�0
03
0
X Nominal capacity [I]
Y Duration [h]
1 2 kW
2 3 kW
3 4 kW
4 6 kW
16.4 Fault conditions
In the event of a fault, temperatures of up to 95 °C at 0.6 MPa
can occur.
16.5 data table
SHW 200 ACE SHW 300 ACE SHW 400 ACE
070074 070075 070076
Hydraulic data
Nominal capacity
l 200 300 400
Amount of mixed water 40 °C (15 °C/60 °C) l 397 590 780
Electrical data
Connected load ~ 230 V
kW 2-4 2-4 2-4
Connected load ~ 400 V kW 2-6 2-6 2-6
Rated voltage V 230/400 230/400 230/400
Phases 1/N/PE, 2/N/PE, 3/PE 1/N/PE, 2/N/PE, 3/PE 1/N/PE, 2/N/PE, 3/PE
Frequency Hz 50/60 50/60 50/60
Single circuit operating mode X X X
Application limits
Temperature setting range
°C 35-82 35-82 35-82
Max. permissible pressure MPa 0.6 0.6 0.6
Test pressure MPa 0.78 0.78 0.78
Max. permissible temperature °C 95 95 95
Max. flow rate l/min 30 38 45
Energy data
Standby energy consumption/24 h at 65 °C
kWh 1.9 2.2 2.7
Versions
IP rating
IP25 IP25 IP25
Sealed unvented type X X X
Colour White White White
Dimensions
Height
mm 1578 1593 1763
Width mm 550 650 700
Depth mm 690 790 840
Weight
Weight, full
kg 254 367 485
Weight, empty kg 54 67 85
WARRAnty | EnvIROnMEnt And
RECyClIng
Warranty
The warranty conditions of our German companies do not
apply to appliances acquired outside of Germany. In countries
where our subsidiaries sell our products, it is increasingly the
case that warranties can only be issued by those subsidiaries.
Such warranties are only granted if the subsidiary has issued
its own terms of warranty. No other warranty will be granted.
We shall not provide any warranty for appliances acquired in
countries where we have no subsidiary to sell our products.
This will not affect warranties issued by any importers.
Environment and recycling
We would ask you to help protect the environment. After use,
dispose of the various materials in accordance with national
regulations.
InStAllAtIOn | WARRAnty | EnvIROnMEnt And RECyClIng
Specification