HONDA 2013 CR-Z - Manual (Page 116)

115
uu Operating the Switches Around the Steering Wheel u Wipers and Washers
The rear wiper and washer can be used when
the ignition switch is in ON
( w .
■ Wiper switch (OFF, ON)
The wiper operates intermittently after
completing a few sweeps.
■
Washer ( )
Sprays while you rotate the switch to this
position.
Hold it to activate the wiper and to spray the
washer. Once released, it stops operating
after a few more sweeps.
■ Operating in reverse
When you shift the transmission to ( R with the front wiper activated, the rear wiper
operates automatically as follows even if its switch is off.
■ Rear Wiper/Washer 1 Rear Wiper/Washer
If the wiper stops operating due to any obstacle such
as the build-up of snow, park the vehicle in a safe
place.
Rotate the wiper switch to OFF, and turn the ignition
switch to ACCESSORY
( q or LOCK ( 0, then remove
the obstacle.
The wiper motor is equipped with a breaker that may
stop motor operation temporarily to prevent an
overload. Wiper operation will return to normal
within a few minutes, once the circuit has returned to
normal.
ON: Intermittent
OFF
Washer
Front Wiper Position Rear Wiper Operation
INT (Intermittent) Intermittent
LO (Low speed wipe)
HI (High speed wipe)
Continuous
13 CR-Z-31SZT6200.book 115 ページ ２０１２年１０月２５日 木曜日 午後９時９分
Home
QRG
Index
2013 CR-Z
Co
ntrols
TOC