HONDA 2013 CR-Z - Manual (Page 286)

285
uu If a Tire Goes Flat u Temporarily Repairing a Flat Tire
7. Remove the side cover, then pull out the
power plug.
8. Plug in the compressor to the accessory
power socket.
u Be careful not to pinch the cord in a
door or window.
9. Start the engine.
u Keep the engine running while injecting
air.
2 Carbon Monoxide Gas P. 62
10. Press the inflator switch to turn on the
compressor.
u The compressor starts to inject air into
the tire.
11. Inflate the tire to the specified air pressure.
12. Turn off the inflator switch.
u Check the pressure gauge on the air
compressor.
u If overinflated, press the pressure relief
button.
13. Unplug the compressor from the
accessory power socket.
14. Unscrew the air only hose from the tire
valve stem. Reinstall the valve cap.
15. Press the pressure relief button until the
gauge returns to 0 psi (0 kPa).
16. Repackage and properly stow the kit.
1 Inflating An Under-inflated Tire
3 WARNING
Running the engine with the vehicle in an
enclosed or even partly enclosed area can
cause a rapid build-up of toxic carbon
monoxide.
Breathing this colorless, odorless gas can
cause unconsciousness and even death.
Only run the engine to power the air
compressor with the vehicle outdoors.
Side Cover
Power Plug
Inflator Switch
Inflator Switch
Pressure
Relief Button
13 CR-Z-31SZT6200.book 285 ページ ２０１２年１０月２５日 木曜日 午後９時９分
Home
QRG
Index
2013 CR-Z
Han
d
lin
g the U
n
expected
TOC