HONDA 2012 Pilot - Manual (Page 183)

Fail to press a memory button
within 5 seconds.
To cancel the storing procedure
after pressing the SET button, do
any of the following:
Pressing the SET button again
within 5 seconds.
Readjusting the outside mirror
position.
Readjust the seat position.
Each memory button stores only one
driving position. Storing a new
position erases the previous setting
stored in that button’s memory. If
you want to add a new position while
retaining the current one, use the
other memory button.
All stored driving positions will be
lost if your vehicle’s battery goes
dead or is disconnected.
To select a memorized position, do
this:
Make sure the shift lever is in the
Park (P) position.
Press the desired memory button
(1 or 2) until you hear a beep, then
release the button.
The system will move the seat and
outside mirrors to the memorized
positions. The indicator in the
selected memory button will flash
during movement. When the
adjustments are complete, you will
hear two beeps, and the indicator will
remain on.
Press any button on the control
panel: SET, 1, or 2.
To stop the system’s automatic
adjustment, do any of these actions:
If desired, you can use the
adjustment switches to change the
positions of the seat or outside
mirrors after they are in their
memorized positions. If you change
the memorized position, the
indicator in the memory button will
go out. To keep this driving position
for later use, you must store it in the
driving position memory.
Adjust the outside mirrors.
Shift out of Park.
Push any of the adjustment
switches for the seat.
1.
2.
Driving Position Memory System
Selecting a Memorized Position
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
175
11/08/01 08:46:29 31SZA630_182