HONDA 2012 Pilot - Manual (Page 597)

Open the tailgate.
Remove the two mounting bolts
with an 8 mm wrench.
Place a cloth on the inner edge of
the assembly to prevent scratches.
Loosen the assembly by carefully
prying on the top and side edges
with a small flat-tip screwdriver.
Use your fingers to further pull it
loose.
Remove the assembly from the
mounting holes by pulling it out.
Remove the electrical connector
from the bulb by pushing on the
tab and pulling the connector
down.
Remove the bulb from the fog
light assembly by turning it one-
quarter turn counterclockwise.
Install the new bulb into the hole
and turn it one-quarter turn
clockwise to lock it in place.
1. 3.
3.
4.
2.
4.
5.
CONTINUED
Replacing Rear Bulbs
(in Rear Pillar)
Lights
Ma
int
e
na
nce
589
CONNECTOR
BULB
11/08/01 11:06:59 31SZA630_596