Dust and pollen filter, cleaning the seat belts – HONDA 2012 Pilot User Manual

Page 601

Advertising
background image

If your seat belts get dirty, use a soft
brush with a mixture of mild soap
and warm water to clean them. Do
not use bleach, dye, or cleaning
solvents. Let the belts air-dry before
you use the vehicle.

This filter removes the dust and
pollen that is brought in from the
outside through the heating and
cooling system/climate control
system.

Dirt build-up in the loops of the seat
belt anchors can cause the belts to
retract slowly. Wipe the insides of
the loops with a clean cloth
dampened in mild soap and warm
water or isopropyl alcohol.

Have your dealer replace the filter
when this service is indicated by a
maintenance message on the
information display or multi-
information display (depending on
the model). It should be replaced
every 15,000 miles (24,000 km) if you
drive primarily in urban areas that
have high concentrations of soot in
the air, or if the flow from the
heating and cooling system/climate
control system becomes less than
usual.

Cleaning the Seat Belts

Dust and Pollen Filter

Dust and Pollen Filter, Cleaning the Seat Belts

Ma

int
e

na
nce

593

LOOP

11/08/01 11:07:40 31SZA630_600

Advertising
This manual is related to the following products: